Aureole Ceramic Wall Light: Care and Cleaning Guide
By Spark & Bell - Handmade Lighting UK | Custom Pendants | Published: 2026-11-03
Category: Tips & Care
Keep your Aureole ceramic wall light looking its best with this step-by-step cleaning and maintenance routine, from dusting glazed discs to changing the bulb safely.
Quick answer
Clean your Aureole ceramic wall light by dusting the glazed discs with a soft, dry cloth and wiping the stoneware with a barely damp cloth, always switching off the power first. Avoid abrasive cleaners and prolonged moisture to protect the bespoke glaze and clay.
Why glazed ceramic needs a gentler routine
The Aureole’s hand-built stoneware discs are glazed on the inside, which gives a smooth, protective finish but can still be vulnerable to harsh chemicals or scratching. Abrasive pads or ammonia-based cleaners may dull the glaze over time, and soaking the clay body can weaken the unglazed areas.
Because the pattern is imprinted into the clay before firing, textured surfaces can trap dust. A soft brush or vacuum with a brush attachment lifts debris without grinding it into the glaze.
When to call a professional
If the wall light is hardwired and you are unsure how to isolate the circuit, or if the fitting shows signs of damage such as cracks or loose connections, stop and consult a qualified electrician. The IP rating option on the Aureole may affect cleaning near moisture—check your specific configuration if installed in a bathroom or outdoor area.
Step-by-step care and cleaning
- Switch off the power: Turn off the wall light at the switch and, for hardwired fittings, isolate the circuit at the consumer unit before touching the fixture. Never clean a live fitting—confirm the power is off with a tester if unsure.
- Dust the glazed discs: Use a soft, dry microfibre cloth or a vacuum with a brush attachment on low suction to gently remove loose dust from the glazed surfaces and the imprinted pattern. Avoid pressing hard or using a stiff brush, which can scratch the glaze.
- Wipe the stoneware body: Dampen a soft cloth with water only—no detergents—and wring it out thoroughly so it is barely damp. Wipe the unglazed clay and metal parts, then dry immediately with a clean cloth. Do not let water sit on the clay or seep into seams; moisture can damage the stoneware over time.
- Clean stubborn marks: For fingerprints or light marks on the glaze, use a pH-neutral soap diluted in water, applied to the cloth not the fixture. Rinse by wiping with a clean damp cloth and dry. Skip abrasive creams, bleach, or ammonia-based cleaners—they can etch the glaze.
- Change the bulb safely: If a bulb needs replacing, let it cool completely, then remove it according to the fitting’s instructions. Handle the new bulb with a clean cloth to avoid oils on the glass, and do not overtighten. Check the bulb type and wattage match the Aureole’s specification; an incorrect bulb can overheat the fitting.
- Inspect and reassemble: Before restoring power, check that all parts are dry and securely fitted. Look for any signs of wear or damage, and tighten any loose screws on the metal finish. If you notice cracks or loose wiring, stop and seek professional advice.
Product facts
- "Aureole" Wall Light - Ceramic: The Aureole wall light is made from flecked stoneware clay with a bespoke swan-feather pattern and glazed discs. The textured clay and glazed finish require gentle cleaning to preserve the handcrafted detail and shine.
"Aureole" Wall Light - Ceramic
